L increases, the becomes much more uneven. Itof the machined surfacefeed rate increases, the material removal price of your machined surface increases, however the overall height deviation of height deviation from the machined surface gradually increased.the machined surface gradually enhanced.Micromachines 2021, 12, x13 ofFigure ten. Impact of feed price on the three-dimensional surface roughness. (Grinding depths: six , Figure 10. Effect of feed rate on the three-dimensional surface roughness. (Grinding depths: six m, Grinding wheel linear speeds: 600 mm/min).Grinding wheel linear speeds: 600 mm/min).(a)(b)Figure 11. Comparison of three-dimensional surface microstructure under unique feedresults.(Grinding depths: 6 m, Grinding wheel linear speeds: 600 mm/min). (a) White light interferometer observation rates. (b) Scanning electron Grinding wheel linear speeds: 600 mm/min). (a) White light interferometer observation results. (b) Scanning electron mimicroscope observation outcomes. croscope observation outcomes.Figure 11. Comparison of three-dimensional surface microstructure under distinct feed prices. (Grinding depths: 6 ,The comparison of predicted and actual values from the three-dimensional surface The comparison of predicted of TUAG under unique grinding wheel linear surface roughness from the Nano-ZrO2 ceramic and actual values with the three-dimensionalspeed roughnessin FigureNano-ZrO2 ceramic of TUAG that because the grinding wheel linear speed is shown from the 12. It might be seen from Figure 12 MNITMT Inhibitor micro-crush damage from the be observed that as the grinding wheel height model of Nano-ZrO2 ceramic ultra-precision grinding surface residual material establishedheight and valley depth of the machined machined surface is weakened, as well as the peak within this study, the observation final results had been surface it might be and that as the height deviation of the machined surface micro-crush analyzed,lower, noticed the general grinding wheel linear speed increases, the decreases progressively. Additionally, the accumulation of residual supplies around the surface through of damage on the machined surface is weakened, and also the peak height and valley depth thethe grinding surface decrease, as well as the overall height deviation of your machined surface machined method is weake.
